Dental Sintering Furnace Nabertherm LHT 03/17D

Dental Sintering Furnace Nabertherm LHT 03/17D

These high-temperature furnaces are ideally suited for sintering bridges and crowns made of translucent zirconia. The special heating elements made of molybdenum disilicide promise the best possible protection against chemical interaction between the charge and the furnace components. The bridges and crowns are loaded in ceramic saggars. These high-temperature furnaces are particularly convincing due to their excellent price-performance ratio. The furnaces can be individually programmed for all recommended sintering curves by almost all zirconium
manufacturers.

Device Specifications

• Tmax 1650 °C
• Furnace chamber with a volume of 1 or 4 liters
• Special heating elements made of molybdenum disilicide offer best possible protection against chemical interaction between charge and heating elements
• Dual shell housing made of textured stainless steel sheets with additional fan cooling for low surface temperature
• Only fiber materials are used which are not classified as carcinogenic according to TRGS 905, class 1 or 2
• Compact design with lift door, opening upwards
• Scope of delivery includes a starter set for charging on one level, additional levels as additional equipment
• Adjustable air inlet
• Furnace chamber can be charged with up to two (LHT 01/17D) or three (LHT 03/17D) saggars, 15 or 25 individual crowns per level (depending on model)
• Exhaust air opening in the roof
• Type S thermocouple
• Precise temperature control, also in the lower temperature range for drying
• Controller P480 (LHT 01/17 D) or P470 (LHT 03/17 D) with memory for 50 programs
• Freely usable for sintering blanks of almost all leading manufacturers
• Defined application within the constraints of the operating instructions
• NTLog Basic for Nabertherm controller: recording of process data with USB-flash drive

Additional equipment

• Over-temperature limiter with adjustable cutout temperature for thermal protection class 2 in accordance with EN 60519-2 as temperature limiter to protect the furnace and load
• Saggar for charging of up to three layers
• Protective gas connection for non-flammable protective or reaction gases for LHT 03/17D
• Manual or automatic gas supply system
• Process control and documentation via VCD software package for monitoring, documentation and control

For any additional information about Dental Sintering Furnace Nabertherm LHT 03/17D you could either Contact Us or the manufacturer using the following link:LHT 03/17 D